Amana dryer repair
Amana Dryer Repair in Maryland
We repair Amana dryers at homes and businesses in Montgomery and Prince George's counties. Gas and electric 29-inch dryers on a long-running Whirlpool design. Thermal fuses, heating elements, igniters, gas valve coils, belts, idler pulleys and rollers are routine repairs.
Booking online works too. With the Amana dryer's model number in the form, we can check part availability before we come.
First the appliance and its location, then your contact details. We follow up to schedule.
dryer brands we repair
Amana Dryer Repair in Houses, Townhomes and Condos
We are independent: not a Amana service center, and not authorized by Amana. If your dryer is still inside the Amana warranty, go to the manufacturer first. Once it's past that coverage, a model number in your booking lets us source parts ahead of the visit.
How a Dryer Repair Visit Works
Book the Visit
Call or use the form. Name the make and describe the fault; a model number, if handy, speeds up parts.
Find the Fault
At your place, the technician checks the appliance and whatever feeds it (power, water, drain, gas or venting) until the cause is clear.
Approve the Price
You get a plain explanation and a price for the repair. The work starts only if you say yes.
Fix and Check
The new part is fitted and the appliance is run through a cycle, so you can see it working.
What's inside an Amana dryer
Amana dryers are 29-inch gas and electric models built on Whirlpool's long-running design, which has been produced in large numbers for years and is simple to work on. When one runs without heat, the thermal fuse is the most likely suspect, and it nearly always blew because of a restricted vent. In an older house, the vent may run a long way through a basement ceiling to the outside, and a lot of lint can build up there. Electric models also lose heating elements, and gas models have igniters and gas valve coils that wear out. As the rollers and idler pulley wear, the dryer squeals or thumps. A broken belt lets the motor run while the drum stays still.
Parts that tend to fail on Amana dryers
- Thermal fuse blown by a restricted vent
- Heating element open
- Gas valve coils weak
- Roller or idler pulley squealing
- Belt broken, drum not turning
Faults that show up whatever the brand are explained in our dryer repair overview.
Where we repair Amana dryers
Local pages for each area we serve. Book a visit when you're ready.
Guides for Amana and other dryers
Amana Dryer Repair Questions
The questions that come up most often. Anything not covered here, ask us when you call, or add it to the booking form's notes field.
Have a different question?
Tell us what make it is and what's going wrong. A few things can be settled over the phone, and anything else gets looked at during the visit.
A blown thermal fuse, usually caused by a vent packed with lint. The fuse gets replaced and the vent gets cleared or inspected, because a clogged vent will blow the new one too. If the fuse is fine, we test the element or the gas ignition.
Worn drum rollers or a worn idler pulley are the usual causes. We replace the worn parts, often as a set, along with the belt if it's cracked.