Ice Maker Repair
Ice Maker Repair in Laurel, MD
A technician visits your Laurel home or business, tests the ice maker where it's installed, and prices the repair before any work.
Booking online works too. Include the ice maker's model number and your Laurel street, and we can check parts first.
First the appliance and its location, then your contact details. We follow up to schedule.
Curious what a technician tests first? See how a ice maker gets diagnosed.
Ice Maker Brands We Repair
9 brands that make ice makers
More Repairs in Laurel
11 other appliance types
Ice Maker repair in Laurel
Ice makers in Laurel townhouses are usually fed by a line run from the kitchen sink or from a valve box in the wall behind the fridge. In detached houses in West Laurel and South Laurel, the line may start at a basement pipe and climb through a hole in the floor, where it can kink when the fridge is pushed back. Older houses near Main Street sometimes route the line along an exterior wall, where a hard January can freeze it.
Isolating supply, temperature and mechanism
We first confirm that water reaches the refrigerator: valve fully open, line free of kinks, filter not clogged and pressure high enough for the inlet valve to fill properly. Then the inlet valve's coil resistance and screen are tested. Freezer temperature comes next, since an ice maker waits until the mold is cold enough before it ejects. If water arrives and the freezer is cold, the module is put through a forced harvest to check its motor, mold heater, thermostat and arm or sensor. Door dispensers get a separate check of the auger motor, actuator switch and chute flap.
Lines through floors and outside walls
An ice maker line that passes along an outside wall or through a crawlspace can freeze in a cold snap and stop ice until it thaws. A line routed through a floor hole can rub and crack over time. Aging plastic tubing is worth replacing with braided or copper line.
At a Glance
Ice Maker Repair Questions
The questions that come up most often. Anything not covered here, ask us when you call, or add it to the booking form's notes field.
Have a different question?
Tell us what make it is and what's going wrong. A few things can be settled over the phone, and anything else gets looked at during the visit.
Ice that floods the tray or fuses into a block usually means the inlet valve isn't closing fully, so water keeps dripping into the mold. Low household pressure can make some valves seep. A failed fill-tube heater or an ice maker module that fills twice can cause the same mess, so we test the valve first and work back from there.
Ice Maker guides for Laurel homes
Ice Maker Problems We Diagnose
- Not Making Ice
- Making Small or Hollow Ice Cubes
- Leaking Water
- Ice Tastes or Smells Bad
- Overfilling with Ice
- Making Loud Noise
- Producing Too Little Ice
- Ice Clumping Together
- Water Leaking from Ice Maker
- Ice Not Dispensing
- Ice Has Bad Taste or Odor
- Producing Small or Hollow Ice Cubes
Ice Maker Repair in Other Areas
Book ice maker repair in Laurel
Call or book online for ice maker repair in Laurel and tell us whether the refrigerator has a door dispenser.
Ice Maker Repair in Houses, Townhomes and Condos
Ice maker repair for refrigerator ice makers and door dispensers in Laurel townhouses, apartments and detached houses, including long supply lines run up from basement plumbing.
How an Ice Maker Repair Visit Works
Book the Visit
Call or use the form. Name the make and describe the fault; a model number, if handy, speeds up parts.
Find the Fault
At your place, the technician checks the appliance and whatever feeds it (power, water, drain, gas or venting) until the cause is clear.
Approve the Price
You get a plain explanation and a price for the repair. The work starts only if you say yes.
Fix and Check
The new part is fitted and the appliance is run through a cycle, so you can see it working.