Appliance Repair in Beltsville & Calverton (20705)

Houses of this age often have a three-prong dryer and range receptacle rather than a newer four-prong one, so check yours if you've just bought a new electric appliance; the cord has to match how the house is wired. Also look at the dryer's outside hood near the foundation to see whether the flap opens, and note whether the basement has a floor drain near the washer.

Split-levels put the laundry in a lower level that is partly below grade, and in July and August that space stays humid. Washers and dryers sweat, steel cabinets rust from the bottom up, and a dryer vent running through a foundation wall near the ground can collect lint and leaves at the hood.

A dehumidifier and a clear path for the vent go a long way. When a washer won't drain, we check the standpipe height and the hose connection as well as the pump, since an old standpipe can be too short or partly clogged.

A spare refrigerator in an attached garage faces summer heat that pushes its compressor hard and winter cold that can leave its freezer warm. Chest freezers handle a garage better than most refrigerators, but they still need clear space around the cabinet so the condenser can shed heat. If either unit runs constantly, clean the coils and check the door seal before anything else.

Many kitchens here have been updated once or twice since they were built, and a modern dishwasher or range may be connected to plumbing or wiring that is decades older. A dishwasher drain feeding an old disposal, a gas range on an original flex connector or a microwave on a shared circuit can each cause trouble that looks like an appliance fault. We check those connections as part of the diagnosis.

To schedule, call or book online with your street and the appliance's location: kitchen, basement, garage or lower level of a split. Mention whether it runs on gas or electric and, if it's easy to find, the model number from the label.